※ 이 가격은 1조 가격이 아니며 한개 가격입니다.

주파수 반응: 47 - 22k Hz (-3 dB)
120 dB SPL (peak) per pair @ 1m with music material
210 mm (8’) 고효율 polymer composite cone driver
Directivity Control Waveguide™(DCW™)가 결합된 25 mm(1’)금속 DOME 트위터
15 liter vented cabinet
Bi-amplified: 120 W, 120 W
전자 크로스오버 및 보호 회로
Built in bass roll-off, 고음,저음 각도 콘트롤

SYSTEM

Lower cut-off frequency, -3 dB:< 47 Hz

Upper cut-off frequency, -3 dB:> 22 kHz

Free field frequency response of system:
48 Hz - 22 kHz ( /- 2 dB)

Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz:
@ 1m > 110 dB SPL
@ 0.5m> 116 dB SPL

Maximum long term RMS acoustic output in same conditions with IEC weighted noise (limited by driver unit protection circuit):
@ 1m> 101 dB SPL
@ 0.5m> 107 dB SPL

Maximum peak acoustic output per pair on top of console, @ 1 m from the engineer with music material:
> 120 dB

Self generated noise level in free field @ 1m on axis:
< 10 dB(A-weighted)

Harmonic distortion at 90 dB SPL @ 1m on axis:
Freq:50...100 Hz< 1%
> 100 Hz< 0.5%

Drivers:
Bass 210 mm (8’) cone
Treble 25 mm (1’) metal dome

Weight:12 Kg(26 lb)

Dimensions:
Height393 mm(15 1/2’)
Width 250 mm( 9 7/8’)
Depth 290 mm(11 7/16’)

AMPLIFIER

Bass amplifier output power with an 8Ohm load:
Short term120 W

Treble amplifier output power with an 8Ohm load:
Short term120 W

Long term output power is limited by driver unit protection circuitry.

Slew rate:80 V/micros

Amplifier system distortion at nominal output:
THD< 0.05%
SMPTE-IM< 0.05%
CCIF-IM< 0.05%
DIM 100< 0.05%

Signal to Noise ratio, referred to full output:
Bass> 100 dB
Treble> 100 dB

Mains voltage:100/200 V or 115/230 V

Voltage operating range at
230V setting:207 - 253 V ( /- 10%)
115V setting:104 - 126 V ( /- 10%)

Power consumption:
Idle30 W
Full output160 W

CROSSOVER

Input connector:
XLR female
pin1 gnd
pin 2
pin 3 -

Input impedance:
10 kOhm balanced

Input level for 100 dB SPL output @ 1m:
variable from 6 to -6 dBu

Input level for maximum short term output of 110 dB SPL @ 1m:
variablefrom 16 to 4 dBu

Subsonic filter below 45 Hz :
18 dB/octave

Ultrasonic filter above 25 kHz:
12 dB/octave

Crossover frequency, Bass/Treble:2.2 kHz

Crossover acoustical slopes:
24 dB/octave

Treble tilt control operating range in 2 dB steps:
from 2 to -4 dB & MUTE

Bass roll-off control operating range in 2 dB steps:
from 0 to -8 dB @ 40 Hz

Bass tilt control operating range in 2 dB steps:
from 0 to -6 dB & MUTE

The ’CAL’ position is with all tone controls set to ’off’ and input sensitivity control to maximum.